Dell N1100-ON

Security Commands 1001
name (Captive Portal)
Use the name command to configure the name for a captive portal
configuration. Use the no form of this command to remove a configuration
name.
Syntax
name cp-name
no name
• cp-name — CP configuration name (Range: 1–32 characters).
Default Configuration
Configuration 1 has the name “Default” by default. All other configurations
have no name by default.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-cp 2)#name cp2
protocol
Use the protocol command to configure the protocol mode for a captive
portal configuration.
Syntax
protocol {http | https}
Default Configuration
The default protocol mode is http.