Layer 3 Routing Commands 1594
User Guidelines
The following information is displayed.
Example
(console)#show ip pim neighbor vlan 10
Up Time Expiry Time
Neighbor Addr Interface hh:mm:ss hh:mm:ss
--------------- ---------- --------- -----------
192.168.10.2 VLAN0010 00:02:55 00:01:15
(console)#show ip pim neighbor
Neighbor Addr Interface Uptime Expiry Time
(HH:MM::SS) (HH:MM::SS)
--------------- --------- ----------- -----------
192.168.10.2 VLAN0001 00:02:55 00:01:15
192.168.20.2 VLAN0010 00:03:50 00:02:10
If no neighbors are learned on any of the interfaces, the following message is
displayed.
No neighbors are learned on any interface.
show ip pim rp-hash
The show ip pim rp-hash command displays the rendezvous point (RP)
selected for the specified group address.
Syntax
show ip pim rp-hash group-address
• group-address — A valid multicast address supported by RP.
Default Configuration
There is no default configuration for this command.
Field Description
Neighbor Addr IP address of the PIM neighbor
Interface Interface number
Uptime Time since the neighbor is learned
Expiry Time Time remaining for the neighbor to expire
To Next Page
Loading...
