Switch Management Commands 1826
Default Configuration
By default, no applications are installed.
Command Mode
Privileged Exec mode
User Guidelines
Applications must be downloaded and installed prior to scheduling execution
with the application start command.
Application names may be up to 16 characters in length.
The name specified in the application-name parameter must match the
filename output of the show application command exactly. Application
names are case sensitive.
Example
console#application start support-assist
Command History
Introduced in version 6.3.0.1 firmware. Example added in the 6.4 release.
application stop
Use the application stop command to stop an application if the application is
executing on the stack master.
Syntax
application stop application-name
• application-name — The name of the application as shown in the show
application command output.
Default Configuration
By default, no applications are started.
Command Mode
Privileged Exec mode
To Next Page
Loading...
