Dell N1100-ON

Layer 2 Switching Commands 335
show dhcp l2relay remote-id vlan
Use the show dhcp l2relay remote-id vlan command to display whether
DHCP L2 Relay is globally enabled and shows the remote ID configured on
the specified VLAN or VLAN range.
Syntax
show dhcp l2relay remote-id vlan vlan-list
• vlan-list — Show information for the specified VLAN range . List separate, non-
consecutive VLAN IDs separated by commas (without spaces). Use a
hyphen to designate a range of IDs. (Range: 1–4093)
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay remote-id vlan 200
DHCP L2 Relay is Enabled.
VLAN ID Remote Id
-------- -------------
200 remote_22
clear dhcp l2relay statistics interface
Use the show dhcp l2relay statistics interface command to reset the DHCP
L2 Relay counters to zero. Specify the port with the counters to clear, or use
the all keyword to clear the counters on all ports.
Syntax
clear dhcp l2relay statistics interface {all | interface-id}