Dell N1100-ON

Layer 3 Routing Commands 1324
Default Configuration
There is no default configuration.
Command Mode
Privileged Exec mode
User Guidelines
There are no usage guidelines.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#show bgp ipv6 listen range
Listen Range.................................. 2001::1/64
Inherited Template............................ template_2001
Member ASN State
--------------------------------------- ----- -----------
2001::10 65001 OPENCONFIRM
2001::20 0 ACTIVE
Listen Range.................................. 2002::1/64
Inherited Template............................ template_2002
Member ASN State
--------------------------------------- ----- -----------
show bgp ipv6 neighbors
Use this command to display neighbors with IPv4 or IPv6 peer addresses that
are enabled for the exchange of IPv6 prefixes. This command deprecates and
replaces the show ipv6 bgp neighbors command.
Syntax
show bgp ipv6 neighbors [ ipv4-address | ipv6-address [ interface interface-
id ] | autodetect interface interface-id ]