Dell N1100-ON

Layer 2 Switching Commands 435
show ethernet cfm maintenance-points local
Use the show ethernet cfm maintenance-points local command to display
the configured local maintenance points.
Syntax
show ethernet cfm maintenance-points local {level 0-7 | interface interface-
id | domain domain-name}
• level—Maintenance association level
• domain—Name of the maintenance domain (an alphanumeric string of
up to 43 characters in length).
• interface-id— Show all MPs associated with the interfa ce. This command
accepts physical interface identifiers and port channel interface identifiers.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec, Global Configuration mode and all Configuration submodes
User Guidelines
Refer to IEEE 802.1ag for an explanation of the maintenance association
level and MEP ID. Typically, these are assigned by the top level network
service provider.
• MPID—The maintenance endpointoint identifier
• Level—The MEP level
• Type—Maintenance endpoint (MEP) or maintenance intermediate point
(MIP)
• VLAN—The configured VLAN id
• Port—The port on which the MEP association is configured
• Direction—(Up)stream or (Do)wnstream
• CC Transmit—Continuity check enabled
• MEP-Active—The MEP administrative status