Security Commands 1055
Syntax
passwords strength minimum special–characters 0–16
no passwords strength minimum special–characters
Default Configuration
The default value is 1.
Command Mode
Global Configuration
User Guidelines
This limit is not enforced unless the passwords strength minimum special-
characters command is configured with a value greater than 0. In other words,
a configuration of 0 allows a password consisting entirely of special characters
to pass strength check validation.
Example
console(config)#passwords strength minimum special–characters 6
passwords strength max-limit consecutive-
characters
Use this command to enforce a maximum number of consecutive characters
that a password can contain. If a user enters a password that has more
consecutive characters than the configured limit, the system rejects the
password. The valid range of consecutive characters is 0–15. The default is 0.
A maximum of 0 means there is no restriction on consecutive characters.
Examples of consecutive characters are ABCDEF or 123456 or !”#$%&’().
Use the no form of this command to reset the maximum consecutive
characters accepted to the default value.
Syntax
passwords strength max-limit consecutive–characters 0–15
no passwords strength max-limit consecutive-characters
To Next Page
Loading...
