Layer 3 Routing Commands 1230
no bgp fast-external-fallover
Default Configuration
Fast external fallover is enabled by default.
Command Mode
BGP Router Configuration mode
User Guidelines
When BGP gets a routing interface down event, BGP drops the adjacency
with all external peers whose IPv4 address is in one of the subnets on the
failed interface. This behavior can be overridden for specific interfaces using
ip bgp fast-external-fallover.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)# bgp fast-external-fallover
bgp fast-internal-fallover
Use the bgp fast-internal-fallover command to configure BGP to
immediately reset the adjacency with an internal peer when there is a loss of
reachability to an internal peer.
Syntax
bgp fast-internal-fallover
no bgp fast-internal-fallover
Default Configuration
By default, fast internal fallover is enabled.
Command Mode
BGP Router Configuration mode
To Next Page
Loading...
