Layer 3 Routing Commands 1424
Syntax
ip igmp last-member-query-count Imqc
no ip igmp last-member-query-count
• Imqc — Query count. (Range: 1-20)
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets 10 as the number of VLAN 2 Group-Specific
Queries.
console#configure
console(config)#interface vlan 2
console(config-if-vlan2)#ip igmp last-member-query-count 10
console(config-if-vlan2)#no ip igmp last-member-query-count
ip igmp last-member-query-interval
Use the ip igmp last-member-query-interval command in Interface
Configuration mode to configure the Maximum Response Time inserted in
Group-Specific Queries which are sent in response to Leave Group messages.
Syntax
ip igmp last-member-query-interval tenthsofseconds
no ip igmp last-member-query-interval
• tenthsofseconds — Maximum Response Time in tenths of a second
(Range: 0-255)
To Next Page
Loading...
