Dell N1100-ON

Layer 2 Switching Commands 559
User Guidelines
This command has no user guidelines.
Example
The following example displays how enable the transmission of local data.
console(config-if-Gi1/0/3)#lldp transmit
lldp transmit-mgmt
Use the lldp transmit-mgmt command in Interface Configuration mode to
include transmission of the local system management address information in
the LLDPDUs. To cancel inclusion of the management information, use the
no form of this command.
Syntax
lldp transmit-mgmt
no lldp transmit-mgmt
Default Configuration
By default, management address information is not included.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to include management information in
the LLDPDU.
console(config-if-Gi1/0/3)#lldp transmit-mgmt