Dell N1100-ON

Layer 3 Routing Commands 1593
InterfaceVLAN0010
ModeSparse
Hello Interval(secs)30
Join Prune Interval(secs)60
DR Priority1
BSR BorderDisabled
Neighbor Count1
Designated Router192.168.10.1
InterfaceVLAN0001
ModeSparse
Hello Interval(secs)30
Join Prune Interval(secs)60
DR Priority1
BSR BorderDisabled
Neighbor Count1
Designated Router192.168.10.1
If none of the interfaces are enabled for PIM, the following message is
displayed:
None of the routing interfaces are enabled for PIM
show ip pim neighbor
Use the show ip pim neighbor command in User Exec or Privileged Exec
modes to display PIM neighbors discovered by PIMv2 Hello messages. If the
interface number is not specified, this command displays the neighbors
discovered on all the PIM-enabled interfaces.
Syntax
show ip pim neighbor [vlan vlan-id]
• vlan-id — A valid VLAN ID for which multicast routing has been enabled.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec modes, Global Configuration mode and all
Configuration submodes