Dell N1100-ON

Switch Management Commands 1984
Default Configuration
This default speed is 9600 for all platforms other than the N1100-
ON/N2100/N3100 Series switches. The N1100-ON/N2100/N3100 Series
switches default to 115200 BAUD.
Command Mode
Line Interface (console) mode
User Guidelines
This configuration applies only to the current session.
Example
The following example configures the console BAUD rate to 9600.
console(config-line)#speed 9600
terminal length
Use the terminal length command to set the terminal length. Use the no
form of the command to reset the terminal length to the default.
Syntax
terminal length value
no terminal length
• value — The length in number of lines. Range: 0–512
Default Configuration
This default value is 24.
Command Mode
Privileged Exec mode