Dell N1100-ON User Manual

Switch Management Commands 2046
Default Configuration
Display of PIMSM traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
console#debug ip pimsm packet
debug ipv6 dhcp
Use the debug ipv6 dhcp command to display debug information about
DHCPv6 client activities and to trace DHCPv6 packets to and from the local
DHCPv6 client. To disable debugging, use the no form of the command.
Syntax
debug ipv6 dhcp
no debug ipv6 dhcp
Default Configuration
Debugging for the DHCP for IPv6 is disabled by default.
Command Mode
Privileged Exec
User Guidelines
This command enabled DHCPv6 packet tracing.
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.

Dell N1100-ON Specifications

General

Power Supply	Internal
Model	N1100-ON
Type	Managed
Form Factor	Rack-mountable
Uplink Ports	SFP+
Power over Ethernet (PoE)	No
Layer	Layer 3
Jumbo Frame Support	Yes
Operating Temperature	0°C to 45°C