Dell N1100-ON

Layer 3 Routing Commands 1781
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config-router)#enable
hostroutesaccept
Use the hostroutesaccept command in Router RIP Configuration mode to
enable the RIP hostroutesaccept mode. Use the no form of the command to
disable the RIP hostroutesaccept mode.
Syntax
hostroutesaccept
no hostroutesaccept
Default Configuration
Enabled is the default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config-router)#hostroutesaccept