Dell N1100-ON

Layer 3 Routing Commands 1687
Area LSA Checksum.............................. 0
OSPF NSSA Specific Information.
Import Summary LSAs............................ Enable
Redistribute into NSSA......................... Enable
Default Information Originate.................. TRUE
Default Metric................................. 250
Default Metric Type............................ Non-Comparable
Translator Role................................ Candidate
Translator Stability Interval.................. 2000
Translator State............................... Disabled
Example #3
The following example shows the length of the area’s flood queue for LSAs
waiting to be flooded within the area.
console #show ip ospf area 1
AreaID......................................... 0.0.0.1
External Routing............................... Import External LSAs
Spf Runs....................................... 10
Area Border Router Count....................... 0
Area LSA Count................................. 3004
Area LSA Checksum.............................. 0x5e0abed
Flood List Length.............................. 0
Import Summary LSAs............................ Enable
show ip ospf asbr
The show ip ospf asbr command displays the internal OSPF routing table
entries to Autonomous System Boundary Routes (ASBR). This command
takes no options.
Syntax
show ip ospf asbr [vrf vrf-name]
• vrf-name—The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
Default Configuration
This command has no default configuration.