Layer 2 Switching Commands 587
no peer-keepalive timeout
• value—The peer keepalive timeout value in seconds. The range is 2 to 15
seconds.
Default Configuration
By default, the keepalive timeout value is 5 seconds.
Command Modes
VPC Domain
User Guidelines
This command configures the peer keepalive timeout value (in seconds). If an
MLAG switch does not receive keepalive messages from the peer for this
timeout value, it takes the decision to transition its role (if required).
The keepalive state machine is not restarted if keepalive priority is modified
post election.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-vpc 1)# peer-keepalive timeout 10
role priority
Use the role priority command to configure the priority value used on a
switch for primary/secondary role selection. The primary switch is responsible
for maintaining and propagating spanning-tree and link-aggregation to the
secondary switch.
Use the no form of the command to return the switch priority to the default
value.
Syntax
role priority value
no role priority
To Next Page
Loading...
