Switch Management Commands 2153
show logging
Use the show logging command to display all logging information, including
auditing status and logging protocol version. Protocol version 1 means that
the messages are logged with the time zone and time resolution up to
milliseconds.
Syntax
show logging
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the state of logging and the SYSLOG
messages stored in the internal buffer.
console#show logging
Logging is enabled
Logging protocol version: 1
Console Logging: Level warnings. Messages : 1 logged, 706 ignored
Monitor Logging: disabled
Buffer Logging: Level informational. Messages : 73 logged, 634 ignored
File Logging: Level emergencies. Messages : 0 logged, 707 ignored
Switch Auditing : enabled
CLI Command Logging: disabled
Web Session Logging : disabled
SNMP Set Command Logging : disabled
Logging facility level : local7
Logging source interface: Vl17
To Next Page
Loading...
