Layer 2 Switching Commands 505
Syntax
ipv6 access-list name
no ipv6 access-list name
• name — Alphanumeric string of 1 to 31 characters uniquely identifying
the IPv6 access list.
Default Configuration
There is no default configuration for this command.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
The following example creates an IPv6 ACL named “DELL_IP6” and enters
the IPv6-Access-List Configuration mode:
console(config)#ipv6 access-list DELL_IP6
console(Config-ipv6-acl)#
ipv6 access-list rename
The ipv6 access-list rename command changes the name of an IPv6 Access
Control List (ACL). This command fails if an IPv6 ACL with the new name
already exists.
Syntax
ipv6 access-list rename name newname
• name — the name of an existing IPv6 ACL.
• newname — alphanumeric string from 1 to 31 characters uniquely
identifying the IPv6 access list.
Default Configuration
There is no default configuration for this command.
To Next Page
Loading...
