Switch Management Commands 1942
no enable
Default Configuration
By default, the default server is enabled. It may be disabled using the no
enable form of the command.
Command Mode
HiveAgent Server Configuration
User Guidelines
Only one HiveAgent server (HiveManager NG) can be enabled.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console(config)# hiveagent
console(conf-hiveagent)#server HiveManagerNG
console(conf-hiveagent-HiveManagerNG)#enable
proxy-ip-address
Use the proxy-ip-address command to configure a proxy server to be used to
contact the HiveManager NG. Use the no form of the command to remove
the proxy server information.
Syntax
proxy-ip-address {ipv4-address | ipv6-address} port port-number username
userid password [encryption-type] password
no proxy-ip-address
• ipv4-address — The IPv4 address of the proxy server in dotted decimal
notation.
• ipv6-address — The IPv6 address of the proxy server in IPv6 notation.
• port-number — The TCP port number of the proxy server. The range is
1–65535. The default is 443.
• userid — The user name used to log into the proxy server.
To Next Page
Loading...
