Dell N1100-ON

Layer 3 Routing Commands 1693
Router......................................... 0
Network........................................ 0
Summary Net.................................... 0
Summary ASBR................................... 0
Type-7 Ext..................................... 0
Opaque Link.................................... 0
Opaque Area.................................... 0
Type-5 Ext..................................... 0
Self-Originated Type-5 Ext..................... 0
Opaque AS...................................... 0
Total.......................................... 0
show ip ospf interface
Use the show ip ospf interface command to display the information for the
VLAN or loopback interface. The long form of the command displays the
configuration of flood blocking.
Syntax
show ip ospf interface [vrf vrf-name][vlan vlan-id | loopback loopback-id]
• loopback-id—A configured loopback interface identifier. (Range: 0-7)
• vlan-id—A configured VLAN identifier. (Range: 0-4093)
• vrf-name—The name of the VRF instance on which the command
operates. If no vrf parameter is given, information for the default (global)
router instance is shown.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.