Dell N1100-ON

Security Commands 1013
User Guidelines
There are no user guidelines for this command.
Example
In this example, all classes of entries in the mac address-table are displayed.
console(config)#captive-portal
console(config-cp)#user 1 name asd
console(config-cp)#configuration 1
console(config-cp 1)#user-logout
console(config-cp 1)#no user-logout
user name
Use the user name command to modify the user name for a local captive
portal user.
Syntax
user user-id name name
• user-id — User ID (Range: 1–128).
• name — user name (Range: 1–32 characters).
Default Configuration
There is no name for a user by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines.
Example
console(config-cp)#user 1 name johnsmith