Security Commands 918
Default Configuration
The message authenticator attribute is enabled by default.
Command Mode
RADIUS Server Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(Config-auth-radius)#msgauth
name (RADIUS server)
Use the name command to assign a name to a RADIUS server. Use the no
form of the command to return the name to the default (Default-RADIUS-
Server). The no form of the command does not require the user to enter the
configured name.
Syntax
name servername
no name
• servername—The name for the RADIUS server (Range: 1 - 32 characters).
Default Configuration
The default RADIUS server name is Default-RADIUS-Server.
Command Mode
RADIUS Server Configuration mode
User Guidelines
Names may only be set for authentication servers, not for accounting servers.
Names may consist of alphanumeric characters and the underscore, dash and
blanks.Embed the name in double quotes to use a name with blanks.
To Next Page
Loading...
