Dell N1100-ON

Layer 2 Switching Commands 437
User Guidelines
Refer to IEEE 802.1ag for an explanation of the maintenance association
level and MEP ID. Typically, these are assigned by the top level network
service provider.
• MEP Id—Local MEP identifier
• RMep Id—Remote MEP identifier
• Level—Connectivity association level
• MAC—Destination MAC address
• VLAN—VLAN on which the MEP is configured
• Expiry timer—The configured MEP expiry timer
• Service Id—The configured service identifier
Example
console# show ethernet cfm maintenance-points remove level 1
------ ------- ----- ----------------- ---- ----------------- -----------
MEP Id RMEP Id Level MAC VLAN Expiry Timer(sec) Service Id
------ ------- ----- ----------------- ---- ----------------- -----------
1 2 1 00:11:22:33:44:55 10 25 serv1
show ethernet cfm statistics
Use the show ethernet cfm maintenance-points remote command to display
the CFM statistics.
Syntax
show ethernet cfm statistics [domain domain-name | level 0-7]
• domain-name—Name of the maintenance domain (an alphanumeric
string of up to 43 characters in length).
• level—Maintenance association level
Default Configuration
This command has no default configuration.