Switch Management Commands 1884
show bootvar
Use the show bootvar command in User Exec mode to display the active
system image file that the device loads at startup.
Syntax
show bootvar [unit]
• unit —Unit number.
Default Configuration
This command has no default configuration.
Command Mode
User Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the active system image file that the device
loads at startup.
console(config)#show bootvar
Image Descriptions
active :
backup :
Images currently available on Flash
unit active backup current-active next-active
----- ------------ ------------ ----------------- -----------------
1 6.0.0.0 9.25.16.57 6.0.0.0 6.0.0.0
To Next Page
Loading...
