Security Commands 999
group
Use the group command to configure the group number for a captive portal
configuration. If a group number is configured, the user entry (Local or
RADIUS) must be configured with the same name and the group to
authenticate to this captive portal instance. Use the no form of this
command to reset the group number to the default.
Syntax
group group-number
no group
• group-number — The number of the group to associate with this
configuration (Range: 1–10).
Default Configuration
The default group number is 1.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-cp 2)#group 2
interface
Use the interface command to associate an interface with a captive portal
configuration. Use the no form of this command to remove an association.
Syntax
interface interface
no interface interface
• interface — An interface or range of interfaces.
To Next Page
Loading...
