Layer 2 Switching Commands 377
Example
console(config)#ip arp inspection vlan 200-300
console(config)#ip arp inspection vlan 200-300 logging
permit ip host mac host
Use the permit ip host mac host command to configure a rule for a valid IP
address and MAC address combination used in ARP packet validation. Use
the “no” form of this command to delete an ARP ACL rule.
Syntax
permit ip host sender-ip mac host sender-mac
no permit ip host sender-ip mac host sender-mac
• sender-ip — Valid IP address used by a host.
• sender-mac —Valid MAC address in combination with the above sender-ip
used by a host.
Default Configuration
There are no ARP ACL rules created by default.
Command Mode
ARP Access-list Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(Config-arp-access-list)#permit ip host 1.1.1.1 mac host
00:01:02:03:04:05
show arp access-list
Use the show arp access-list command to display the configured ARP ACLs
with the rules. Giving an ARP ACL name as the argument would display only
the rules in that ARP ACL.
To Next Page
Loading...
