Dell N1100-ON

Layer 2 Switching Commands 553
Default Value
Transmission and reception of LLDP-MED TLVs is enabled on all supported
interfaces.
User Guidelines
No specific guidelines.
Example
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)#lldp med
lldp med confignotification
This command is used to enable sending topology change notifications.
Syntax
lldp med confignotification
no lldp med confignotification
Command Mode
Interface Configuration (Ethernet) mode
Default Value
By default, notifications are disabled on all physical interfaces.
User Guidelines
There are no guidelines for this command.
Example
console(config)#lldp med confignotification
lldp med faststartrepeatcount
This command is used to set the value of the fast start repeat count.