Layer 2 Switching Commands 558
The default hold-multiplier is 4.
The default delay before reinitialization is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Examples
The following example displays how to configure LLDP to transmit local
information every 1000 seconds.
console(config)#lldp timers interval 1000
The following example displays how to set the timing parameter at 1000
seconds with a hold multiplier of 8 and a 5 second delay before
reinitialization.
console(config)#lldp timers interval 1000 hold 8 reinit 5
lldp transmit
Use the lldp transmit command in Interface Configuration mode to enable
the LLDP advertise (transmit) capability. To disable local data transmission,
use the no form of this command.
Syntax
lldp transmit
no lldp transmit
Default Configuration
LLDP is enabled on all supported interfaces.
Command Mode
Interface Configuration (Ethernet) mode
To Next Page
Loading...
