Dell N1100-ON

Security Commands 933
Syntax
retransmit retries
• retries — Specifies the retransmit value. (Range: 1-10 attempts)
Default Configuration
The default number for attempts is 3.
Command Mode
RADIUS mode
User Guidelines
User must enter the mode corresponding to a specific RADIUS server before
executing this command.
Example
The following example of the retransmit command specifies five retries.
console(config)#radius-server host 192.143.120.123
console(config-auth-radius)#retransmit 5
show aaa servers
Use the show aaa servers command to display the list of configured RADIUS
servers and the values configured for the global parameters of the RADIUS
servers.
Syntax
show aaa servers [accounting | authentication] [name [servername]]
• accounting—This optional parameter will cause accounting servers to be
displayed.
• authentication—This optional parameter will cause authentication servers
to be displayed.
• name—This optional parameter will cause the server names to be
displayed instead of the server configuration parameters.