Security Commands 998
• cp-id — Captive Portal ID (Range: 1–10).
Default Configuration
Configuration 1 is enabled by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-cp)#configuration 2
console(config-cp 2)#
enable
Use the enable command to enable a captive portal configuration. Use the no
form of this command to disable a configuration.
Syntax
enable
no enable
Default Configuration
Configurations are enabled by default
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-cp 2)#no enable
To Next Page
Loading...
