Dell N1100-ON

Layer 3 Routing Commands 1371
Updated in version 6.3.0.1 firmware.
Example
console#show ip bgp traffic
Time Since Counters Cleared: 55223 Seconds
BGP Message Statistics
Open Update Notification Keepalive Refresh Total
Recd: 6 11 0 7888 0 7905
Sent: 8 56 3 8465 0 8532
Max Received UPDATE rate: 1 pps
Max Send UPDATE rate: 5 pps
BGP Queue Statistics
Current Max Drops Limit
Events 0 2 0 800
Keepalive Tx 0 3 0 128
Dec Proc 0 3 0 133
Rx Data 0 3 0 500
RTO Notifications 0 4 0 1222
MIB Queries 0 0 0 5
show ip bgp update-group
This command reports the status of IPv4 outbound update groups and their
members.
Syntax
show ip bgp [vrf vrf-name] update-group [group-index | peer-address ]
• vrf vrf-name — Displays the aggregate address information associated
with the named VRF.
• group-index—(Optional) If specified, this option restricts the output to a
single update group.
• peer-address—(Optional) If specified, this option restricts the output to
the update group containing the peer with the given IPv4 address.
Default Configuration
By default, information about the global VRF is shown.