Audio Visual Bridging Commands 1115
Propagation Delay.............................. 0
Port Role...................................... Disabled
PDELAY Threshold............................... 2500
PDELAY lost responses allowed.................. 3
Neighbor Rate Ratio............................ 0
Initial Sync Interval.......................... -3
Current Sync Interval.......................... -3
Initial Pdelay Interval........................ 0
Current Pdelay Interval........................ 0
Initial Announce Interval...................... 3
Current Announce Interval...................... 0
Sync Receipt Timeout........................... 3
Announce Receipt Timeout....................... 3
dot1as interval sync
Use this command to configure the sync interval for an interface. Use the no
form of the command to return the sync interval to the default.
Syntax
dot1as interval sync int-val
no dot1as interval sync
• int-val— The time sync interval in log base 2 format. The range is –5 to 5.
Default Configuration
By default, the initial sync interval is –3.
Command Mode
Interface Configuration
User Guidelines
This value is the logarithm to the base 2 of the desired mean time interval
between successive time-synchronization event messages sent by the link
peer.
IEEE 802.1AS must also be enabled globally as well as on an interface to
become operational.
To Next Page
Loading...
