Security Commands 923
Example
This command configures the switch to send the Service-Type attribute in the
Access-Request message sent to the RADIUS server.
console#conf
console(config)#radius-server attribute 6 on-for-login-auth
radius-server attribute 8
Use the radius-server attribute 8 command to enable the switch to send the
RADIUS Framed-IP-Address attribute in authentication messages sent to the
authentication server.
Syntax
radius-server attribute 8 include-in-access-req
no rradius-server attribute 8 include-in-access-req
Default Configuration
By default, the switch does not send the Framed-IP-Address attribute to the
authentication server.
Command Mode
Global Configuration
User Guidelines
The switch sends the IP address of the host attempting to access the network
in the Framed-IP-Address attribute.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#radius-server attribute 8 include-in-access-req
To Next Page
Loading...
