Dell N1100-ON

Switch Management Commands 2145
logging monitor
Use the logging monitor command in Global Configuration mode to enable
logging messages to telnet and SSH sessions with the default severity level.
Use the no logging monitor command to disable logging messages.
Syntax
logging monitor severity
no logging monitor
• severity—(Optional) The number or name of the desired severity level.
Range:
– [0 | emergencies]
– [1 | alerts]
– [2 | critical]
– [3 | errors]
– [4 | warnings]
– [5 | notifications]
– [6 | informational]
– [7 | debugging]
Default Configuration
The default logging monitor severity level is warnings. By default, logging
messages are not displayed on SSH or telnet sessions (no logging monitor
warnings). Logging messages are displayed by default on console sessions
(serial and out-of-band ports).
Command Mode
Global Configuration mode
User Guidelines
Messages logged to the console are filtered based on severity. Selecting a
severity level will log that severity and higher (numerically lower) level
messages.