Dell N1100-ON

Layer 2 Switching Commands 683
Syntax
match cos
• cos-value — Specifies the CoS value as an integer (Range: 0–7)
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition to the specified
class.
console(config-classmap)#match cos 1
match destination-address mac
Use the match destination-address mac command in Class-Map
Configuration mode to add a match condition based on the destination MAC
address of a packet.
NOTE: This command is not available on the N1500 Series switches.
Syntax
match destination-address mac macaddr macmask
• macaddr — Specifies any valid layer 2 MAC address formatted as six two-
digit hexadecimal numbers separated by colons.
• macmask — Specifies a valid layer 2 MAC address bit mask formatted as
six two-digit hexadecimal numbers separated by colons. This address bit
mask does not need to be contiguous.