Dell N1100-ON

Layer 2 Switching Commands 303
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
In this example, the mac address table entry for 0000.E26D.2C2A is
displayed.
console#show mac address-table address 0000.E26D.2C2A
Vlan Mac Address Type Port
---- -------------- -------- -------------
1 0000.E26D.2C2A Dynamic Gi1/0/1
show mac address-table count
Use the show mac address-table count command in User Exec or Privileged
Exec mode to display the number of addresses present in the Forwarding
Database.
Syntax
show mac address-table count [vlan vlan-id | interface interface-id]
• interface-id — Specify an interface type; valid interfaces include Ethernet ports
and port channels.
• vlan-id — Specify a valid VLAN, the range is 1 to 4093.
Default Configuration
This command has no default configuration.