Security Commands 908
acct-port
Use the acct-port command to set the port on which the RADIUS accounting
server listens for connections. Use the no form of this command to reset the
port to the default.
Syntax
acct-port port
no acct-port
• port — The layer 4 port number of the accounting server (Range: 1 -
65535).
Default Configuration
The default value of the port number is 1813.
Command Mode
RADIUS Server Accounting mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets port number 56 for accounting requests.
console(config)#radius-server host acct 3.2.3.2
console(Config-acct-radius)#acct-port 56
auth-port radius-server attribute 31 source-ip
deadtime radius-server deadtime timeout
key radius-server host usage
msgauth radius-server key
–
name (RADIUS server) radius-server retransmit
–
To Next Page
Loading...
