Dell N1100-ON

Layer 3 Routing Commands 1747
Default Configuration
Passive interface mode is disabled by default.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface vlan 1
passive-interface default
The passive-interface default command enables the global passive mode by
default for all interfaces. It overrides any interface level passive mode. Use the
“no” form of this command to disable the global passive mode by default for
all interfaces. Any interface previously configured to be passive reverts to non-
passive mode.
Syntax
passive-interface default
no passive-interface default
Default Configuration
Global passive mode is disabled by default.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-rtr)#passive-interface default