Dell N1100-ON

Switch Management Commands 2222
console#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Switch Status Model ID Model ID Status Version
--- ---------- --------- ------------- ------------- ------------- ---------
1 Mgmt Sw N3024 N3024 OK 6.0.0.0
2 Stack Mbr N3024 N3024 Updating Code 6.0.0.0
console#show switch 1
Switch............................ 1
Management Status................. Management Switch
Switch Type....................... 0x63400004
Preconfigured Model Identifier.... N3048P
Plugged-in Model Identifier....... N3048P
Switch Status..................... OK
Switch Description................ Dell Networking N3048P
Detected Code Version............. 6.0.0.0
Detected Code in Flash............ 6.0.0.0
SFS Last Attempt Status........... None
Serial Number..................... 13820M0230LF
Up Time........................... 0 days 3 hrs 1 mins 13 secs
Example – SDM Templates
This example shows the SDM Mismatch value in the Switch Status field.
console(config)#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Status Status Model ID Model ID Status Version
--- ---------- --------- ------------- ------------- ------------- ---------
1 Mgmt Sw N4032F N4032F SDM Mismatch 10.7.14.21
show system
Use the show system command to display system information.
Syntax
show system [unit]
• unit — The unit number.
Default Configuration
This command has no default configuration.