Layer 3 Routing Commands 1520
Syntax
ipv6 mld host-proxy [interface vlan-id]
no ipv6 mld host-proxy [interface vlan-id]
Default Configuration
MLD Proxy is disabled by default.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld host-proxy
ipv6 mld host-proxy reset-status
Use the ipv6 mld host-proxy reset-status command to reset the host interface
status parameters of the MLD Proxy router. This command is only valid when
MLD Proxy is enabled on the interface.
Syntax
ipv6 mld host-proxy reset-status
Command Mode
Interface Configuration (VLAN) mode.
Default Configuration
There is no default configuration for this command.
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
