Dell N1100-ON

Security Commands 864
clear authentication authentication-history
Use this command to clear the authentication history logs.
Syntax
clear authentication authentication-history {interface-id | all}
• interface-id—The interface.
• all—All interfaces.
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged Exec mode
User Guidelines
None
Example
console(config)# clear authentication authentication-history Gi1/0/1
enable password
Use the enable password command in Global Configuration mode to set a
local password to control access to the privileged Exec mode. To remove the
password requirement, use the no form of this command.
Syntax
enable password password [encrypted]
no enable password
• password — Password for this level (Range: 8- 64 characters). The special
characters allowed in the password include ! # $ % & ‘ " ( ) * + , - .
/ : ; < = > @ [ \ ] ^ _ ` { | } ~. User names can contain blanks
if the name is surrounded by double quotes. To use the ! character as part
of the username or password string, it should be enclosed within quotation
marks. For example, username “test!xyz” password “test!xyz”.