Switch Management Commands 1902
• ip-address1—The IPv4 address of the first default router for the DHCP
client.
• ip-address2—The IPv4 address of the second default router for the DHCP
client.
Default Configuration
No default router is configured.
Command Mode
DHCP Pool Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config-dhcp-pool)#default-router 192.168.22.1 192.168.23.1
dns-server (IP DHCP Pool Config)
Use the dns-server command in IP DHCP Pool Configuration mode to set
the IP DNS server address which is provided to a DHCP client by the DHCP
server. DNS server address is configured for stateless server support.
Syntax
dns-server ip-address1
no dns-server
• ip-address1—A valid IPv4 address.
Default Configuration
This command has no default configuration.
Command Mode
IP DHCP Pool Configuration mode
To Next Page
Loading...
