Layer 3 Routing Commands 1685
show ip ospf abr
The show ip ospf abr command displays the internal OSPF routing table
entries to Area Border Routers (ABR). This command takes no options.
Syntax
show ip ospf abr [vrf vrf-name]
• vrf-name—The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N3100/N4000 series
switches.
Example
console#show ip ospf abr
Type Router Id Cost Area ID Next Hop Next Hop
Intf
----- --------- ----- --------------- --------- --------
INTRA 3.3.3.3 1 0.0.0.1 10.1.23.3 vlan11
INTRA 4.4.4.4 10 0.0.0.1 10.1.24.4 vlan12
show ip ospf area
Use the show ip ospf area command to display information about the
identified OSPF area.
To Next Page
Loading...
