Dell N1100-ON

Dell EMC Networking CLI 121
Loop Protection
MLAG
show lldp med interface Displays a summary of the current LLDP MED
configuration for a specific interface.
PE
show lldp med local-device
detail
Displays the advertised LLDP local data in
detail.
PE
show lldp med remote-
device
Displays the current LLDP MED remote data. PE
show lldp remote-device Displays the current LLDP remote data. PE
show lldp statistics Displays the current LLDP traffic statistics. PE
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
a. For the meaning of each Mode abbreviation, see Mode Types .
keepalive (Interface Config) Enables loop protection on an interface. IC
keepalive (Global Config) Globally enable loop protection and
optionally configure the loop protection
timer and packet count.
GC
keepalive action Configure the action taken when a loop is
detected on an interface.
IC
show keepalive Displays the global loop protect
configuration.
PE
show keepalive statistics Displays the loop protect status for one or all
interfaces.
PE
Command Description Mode
a
clear vpc statistics Clears the counters for the keepalive
messages transmitted and received by the
MLAG switch.
PE
feature vpc Enables debug traces for the specified
protocols.
GC
Command Description Mode
a