Dell N1100-ON

Switch Management Commands 2000
Examples
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)# power inline priority high
power inline reset
Use the power inline reset command to reset the port.
Syntax
power inline reset
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration
User Guidelines
This command is useful if the port is stuck in an Error state. Power to the
powered devices may be interrupted as the port is reset.
power inline usage-threshold
The power inline usage-threshold command configures the system power
usage threshold level at which lower priority ports are disconnected. The
threshold is configured as a percentage of the total available power. Use the
no form of the command to set the threshold to the default value.
Syntax
power inline usage-threshold [unit unit-id] threshold
no power inline usage-threshold [unit unit-id]
• threshold— Power threshold at which ports are disconnected. The range
is 1-99%.
• unit-id— A stack member identifier.