Layer 2 Switching Commands 289
User Guidelines
This command has no user guidelines.
Example
In this example, the mac address-table tables are cleared.
console#clear mac address-table dynamic
mac address-table aging-time
Use the mac address-table aging-time command in Global Configuration
mode to set the aging time of the address. To restore the default, use the no
form of the mac address table aging-time command.
Syntax
mac address-table aging-time {0 | 10-1000000}
no mac address-table aging-time
• 0—
Disable aging time for the MAC Address Table.
•
10-1000000
—
Set the
number of seconds
aging time for the MAC Address
Table.
Default Configuration
300 seconds
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
In this example the MAC Address Table aging time is set to 400.
console(config)#mac address-table aging-time 400
To Next Page
Loading...
