Security Commands 915
Syntax
auth-port auth-port-number
• auth-port-number — Port number for authentication requests. (Range: 1 -
65535)
Default Configuration
The default value of the port number is 1812.
Command Mode
RADIUS Server Configuration mode
User Guidelines
User must enter the mode corresponding to a specific RADIUS Server
Configuration before executing this command.
Example
The following example sets the port number 2412 for authentication
requests.
console(config)#radius-server host 192.143.120.123
console(config-auth-radius)#auth-port 2412
deadtime
Use the deadtime command in RADIUS Server Configuration mode to
configure the minimum amount of time to wait before attempting to
recontact an unresponsive RADIUS server. If a RADIUS server is currently
active and responsive, that server will be used until it no longer responds.
RADIUS servers whose deadtime interval has not expired are skipped when
searching for a new RADIUS server to contact.
Syntax
deadtime deadtime
• deadtime — The amount of time that the unavailable server is skipped
over. (Range: 0-2000 minutes)
To Next Page
Loading...
