Dell N1100-ON

Layer 2 Switching Commands 718
Example
The following example shows how to display all interfaces in the system to
which a DiffServ policy has been attached.
console(config)#show diffserv service brief
DiffServ Admin Mode............................ Enable
Interface Direction OperStatus Policy Name
----------- ----------- ---------- -------------------------------
Po47 In Down DELL
Gi1/0/1 In Down DELL
Po48 In Down DELL
Gi1/0/2 In Down DELL
show interfaces cos-queue
Use the show interfaces cos-queue command to display the class-of-service
queue configuration for the specified interface.
Syntax
show interfaces cos-queue [{gigabitethernet unit/slot/port | port-channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
If the interface is specified, the class-of-service queue configuration of the
interface is displayed. If omitted, the most recent global configuration
settings are displayed.
Examples
The following example displays the COS configuration with no unit/slot/port
or port-channel parameter.