Layer 3 Routing Commands 1630
area nssa no-redistribute
Use the area nssa no-redistribute command in Router OSPF Configuration
mode to configure the NSSA Area Border router (ABR) so that learned
external routes are not redistributed to the NSSA.
Syntax
area area-id nssa no-redistribute
no area area-id nssa no-redistribute
• area-id — Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the NSSA ABR.
console(config-router)#area 20 nssa no-redistribute
area nssa no-summary
Use the area nssa no-summary command in Router OSPF Configuration
mode to configure the NSSA so that summary LSAs are not advertised into
the NSSA.
Syntax
area area-id nssa no-summary
no area area-id nssa no-summary
• area-id — Identifies the OSPF NSSA to configure. (Range: 0–4294967295)
To Next Page
Loading...
