Dell N1100-ON

Security Commands 1020
Default Configuration
There is no default configuration for this command.
Command Mode
Captive Portal Configuration mode
User Guidelines
The new group-id must already exist.
Example
console(config-cp)#user group 2
console(config-cp)#user 1 group 2
console(config-cp)#user group 2 moveusers 3
user group name
Use the user group name command to configure a group name.
Syntax
user group group-id name name
• group-id — Group ID (Range: 1–10).
• name — Group name (Range: 1–32 alphanumeric characters).
Default Configuration
User groups have no names by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-cp)#user group 2 name group2